ben10_'s Pressure Plates

ben10_'s Pressure Plates

Welcome to Pressure Plates! This is a lightweight, server-friendly pressure plate mod that opens nearby doors smoothly and reliably for your base. It has multiple plate types and works with single doors, double doors, trapdoors, and gates, with smart handling to prevent glitchy behavior. It’s built to stay fast, clean, and scalable even on busy servers.

MAKE SURE TO READ THE HOW TO CRAFT SECTION

What it does:

Adds 8 pressure plate variants (same behavior, different look):

Hardwood, Darkwood, Drywood, Lightwood

Stone, Marble, Shale, Volcanic

Stepping on a plate opens adjacent doors, stepping off closes them after a short delay

Doors and Gates won’t open into blocked spaces, to prevent glitches and keep reliable behavior

Designed to run smoothly on both small worlds and busy multiplayer servers

Built with server performance in mind, so it stays smooth and reliable as your server grows

How to craft:

All plates are crafted using the regular Workbench(Tinker section, new as of 0.9.0) or Builders Workbench

All wooden-based plates require their respective log type, or plank type(decorative and ornate etc. is fine)

All stone-based plates require their respective RAW MATERIAL of the rock(like cobblestone), it will NOT take the Brick, Ornate, Decorative, or Smooth variant!

Crafting take 1 resource for 1 plate

Works with:

Single doors

Double doors (both doors always open/close together)

Gates - either side-by-side, stacked, or both

Trapdoors

Multiple different worlds!

Admin Tools:

Pressure plates placed using creative tools or commands will NOT function until this command is run

Plates placed normally by players will work automatically

If any plates ever stop working (for example after admin edits or world edits), run this command near them to repair detection

/pp scan <chunkRadius> <yRadiusBlocks> (Creative only)

Scans loaded chunks around you to detect pressure plates and repair functionality. First argument is radius around you(in chunks, which are 32x32), second is how far up and down(in blocks, to avoid scanning the whole chunk)

Suggestions are welcomed!